Primitive Angel Craft Project

Primitive Angel Craft Project
Primitive Angel Craft Project

Craft Projects - Oh My Stars - Primitive Angel

This primitive angel wood craft project was Kindly Contributed by: Donna of Front Porch Primitives For more wood craft projects like this, click here to visit Donna's design gallery.

Copyright ©Front Porch Primitives. All Rights Reserved

Supplies: 1/2" plywood for body and wings; 3/4" pine scrap for heart; 19 gauge wire; 2 (3/4") screws; 2 (1") screws; 1 1/2" grapevine star; sawtooth hanger; staple gun; tacky glue; 1/2" block stencil for wings; 1/2" star stencil for wings; stencil brush.

Instructions: Trace angel body and wings pattern onto 1/2" plywood. Trace heart onto 3/4" pine. Paint sides and fronts of each piece as follows:

Angel Face: Fleshtone; Angel Body: Prussian Blue; Wings: Parchment; Heart: Sonoma Wine.

Click Here for Pattern Piece 1

Click Here for Pattern Piece 2

After paint dries, sand sides and front edges of all pieces heavily and surface lightly. Blush cheeks by lightly dipping stencil brush into Sonoma wine paint. Brush most of the paint off the brush onto a paper towel and rub stencil brush over cheek area. Add two small dots for eyes with black paint. Place 1/2” block stencil on wings and stencil with trail tan. When dry stencil two large stars on wings with raw sienna. You can make your own large star stencil with the pattern provided and blank stencil material by tracing star pattern on stencil material and cutting on traced line with an Exacto knife. Or you may purchase your own. Speckle black paint on angel body and wings. Make sure you cover the angel's face to avoid speckling there.

Assembly: Attach saw tooth hanger to top center back of wings. Cut a piece of 19 gauge wire about 6 inches long. Form a circle for the halo and wrap end of wire from circle around itself to secure. Bend remaining wire straight down and attach with a 3/4” staple and staple gun so the end of the wire and staple will be hidden by the wings. Attach wood heart with two 1” screws. Attach wings with two 3/4” screws or attach with 3/4” nails and brad nailer. Glue grapevine star to heart and let dry completely. Hang With Pride.

For more wood craft projects like this, click here to visit Donna's design gallery.

Back